c4-73 type centrifugal fan for the discharge containing dust, wood debris, fine fiber protection and other gases of special equipment, can also be used as general ventilation. (If hard particles are discharged, a dust removal device must be added to the front of the fan inlet).

  The structure form of the fan
  c4-73 type centrifugal fan is mainly composed of impeller, chassis, air inlet, rack transmission part and motor. The impeller part consists of 12 rear tilt wing blades, curved front disks and flat rear disks. Leaf blade, front plate and rear plate are all made of 16 manganese plate. The whole impeller diameter is too dynamic, static balance correction, good air performance, high efficiency, smooth operation.

  The chassis is made as a whole, and the impeller is installed and disassembled on one side of the chassis. The air inlet is made into a whole and is mounted on the side of the fan.
  The cross section parallel to the axis is a curved shape, which can make the gas enter the impeller smoothly and the loss is small. The transmission part is composed of spindle, bearing box, rolling bearing and belt wheel. The fan can be made into two forms of right rotation and left rotation. Facing from one end of the pulley, the impeller rotates clockwise, called the right rotating fan, expressed as "right". Rotate counterclockwise, called a left rotating fan, expressed as "left".

  Known as the right rotating fan, expressed as "right".
Rotate counterclockwise, called a left rotating fan, expressed as "left". The outlet position of the fan is indicated by the outlet angle of the chassis, and the adjustment range is between the 0°~225° and the interval 45°. Factory are made into a form, the use of units as needed to be installed into the required angle. There is no need to specify the loan.

  The fan adopts triangle Belt drive, which can be adjusted according to the provisions of the performance table when the requirements for change in pressure and flow are recorded.